Backyard roofs how to#
Backyard roofs install#

If you wish to elevate the porch roof up to 20 inches, it is necessary to remove the gutter, fascia, and eaves. Since you have the gutter removed, the use of transfer flashing from the house roof to the porch will be compulsory.įurthermore, removing the house gutter typically lets you add up to 4 inches of extra height. Thus, you can set the backchannel in an upper position. If you want to make the porch roof a bit higher, it is necessary to get rid of the existing house gutter. While this method is pretty simple to perform, it does not let you adjust the height of your patio roof. To proceed with this technique, you should fix the backchannel to the fascia board by strengthening two rafters inside the covering. This is one of the most common methods to connect a patio roof to an existing house. After that, seal the brackets from the facade accordingly. You can also incorporate additional flashing wall covering to get a cleaner and more finished look. Hence, installing this feature between the barge cap and the patio roof will allow more daylight to pass through. However, if you prefer to get some natural light, opt for using opaque twin-wall sheeting. If you wish to block natural light from pasting to the patio, consider filling the gap between the barge cap and the porch roof. A bunch of striking choices for the calming ambiance and the finishing look are available as well. Then, these will require a customized barge cap to lift the roof of your patio.įurther, utilizing riser brackets let you elevate the ceiling up to 2 ft. To achieve a particular height, you can take advantage of some riser brackets. You just need to ensure that you take the right way to attach your patio roof since they come with their own pros and cons.įor your reference, here are a few different methods to connect a porch roof to an existing house that you can pick.

Backyard roofs how to#

How to Connect a Porch Roof to a House in Five Different Ways Once properly installed, outline the patio roof by connecting the planks horizontally across the rafters.

Backyard roofs install#

Install the rafters carefully until they fit on the top of the beam.

Assemble the outer rafters and install their beam to the rim of the house roof.

Then, set it flush with the roof of your existing house.

Use a nail gun to connect the horizontal beam.

Trim one side of the horizontal roof beams at an angle carefully to make sure the rafters sit flush on it later.

Take a screwdriver and lag bolts to fasten the base of the roof posts to the ground.

Start with measuring the sightline clearance height from the house roof and the required beam sizes.

Meanwhile, the common steps to attach a patio roof to an existing house are as follows. In general, you need to prepare the following materials before connecting a porch roof to an existing house: Wooden beams lag bolts rafters Black roofing felt planks roofing shingles Screwdriver Ledger nails oriented strand board nail gun utility knife However, if you are not good enough in basic construction skills, experts’ support should be enough to make the most of your patio roof installation.

With some basic construction or woodworking knowledge and skills, attaching a patio roof should not be an issue.

Step-by-Step to Connect a Patio Roof to an Existing House Moreover, read on to discover how to attach a patio roof to an existing house and some of the best ideas to get you inspired. Thus, installing a patio roof will be a great move.Ī patio roof will not only protect you from the weather but also give the building a sense of grandness while boosting the curb’s appeal. Nevertheless, the idea of dazzling sunlight and pouring rain may make you think twice to use this outdoor area for a long time. When furnished with an outdoor chair and table, your patio will be the next favorite spot to sit back and get relaxed.